Control Z1 HDR, NR and ISO with USB API?

[craig]

@drewgardner1

I tried increasing the delay and it hasn’t failed since so it may be fine as is, but I wanted to look into alternate options.

what delay do you have it set to?

Another option is to check the camera status prior to taking the picture and if the camera status is not {"state": "done}, then check the status again.

ricohapi/theta-api-specs/blob/main/theta-web-api-v2.1/protocols/commands_status.md

---

saving settings

Did you try saving the _filter : hdr settings to MySettings?

Stitching mode was not preserved between sleep modes

hi, I’m testing with USB API (gphoto2) now. I set stitching mode to 2(dual fisheye) and took some photos, and I stopped shooting for a few minutes. the camera entered sleep mode. so I set d80e to 0 to wake up the camera and continued shooting again. all the photos after waking up were shooted in stitching mode auto(default=1). is this by design or a bug? refs: 0xD80E SleepMode 0xD834 Image Stitching

I have not tested it, but I think if you save the hdr in mysettings, it will be preserved

Saving HDR _filter Setting to mySetting

THETA Z1 and SC2 can save shooting conditions set with a smartphone or the API. Shooting conditions registered in My Settings can be enabled by the end user by pressing and holding the Function (Fn) button on the THETA. The advantage is that you can save your shooting conditions and use them even while not connected to a smartphone. Does My Setting survive reboot and sleep? I tested Z1 and SC2. Testing with Z1 running firmware 1.60.1. Take a picture with Z1. You can check whether the picture …